LINKDATA INR21700S-50P 21700 Lithium-ion Cell
One cell supplies at least 5,000 mAh and 18.0 Wh in the manufacturer’s standard 1 A discharge test to 2.50 V at 25 ± 2°C.
Technical Specifications
| Specification | Value |
|---|---|
| Model | INR21700S-50P |
| Manufacturer | Linkdata New Energy Co., Ltd. |
| Format | 21700 cylindrical rechargeable lithium-ion cell |
| Minimum standard discharge capacity | 5,000 mAh at 1 A to 2.50 V and 25 ± 2°C |
| Typical capacity | N/A |
| Nominal voltage | 3.6 V |
| Minimum standard discharge energy | 18.0 Wh at 1 A to 2.50 V and 25 ± 2°C |
| Continuous discharge | 50 A without the 80°C cutoff, or 80 A with an 80°C cell-surface cutoff (§3.11). |
| Bare-cell weight | 67.0 ± 1.5 g |
| Cell dimensions with sleeve | 21.35 ± 0.15 mm diameter × 70.7 ± 0.2 mm height, including the grey sleeve. |
Pack-design limits. The 80 A figure in §3.11 applies to a cell with an 80°C cutoff. For pack design, §10.1 specifies a 50 A limit per cell in English and below 50 A in Chinese. Section 13 gives the Chinese text precedence. Section 10.2 specifies overcurrent shutdown above approximately 60 A per cell.
Safety Warning
Use a compatible charger and a pack with overcharge, overdischarge and overcurrent protection. Follow the charging limits in the safety instructions. Keep the terminals insulated and avoid using cells with a damaged sleeve.
Cell Specification
| Specification | Value |
|---|---|
| Cell model | INR21700S-50P |
| Standard discharge capacity | ≥5,000 mAh after standard charge and a 30-minute rest, discharged at 1 A to 2.50 V at 25 ± 2°C (§§3.1, 6.1.1). |
| Rated discharge capacity (10C) | 96% of standard discharge capacity at 50 A (10C) to 2.50 V at 25 ± 2°C (§6.1.4). |
| Nominal voltage | 3.6 V |
| Standard charge | 5 A constant current to 4.20 V, then constant voltage until current falls to 100 mA at 25 ± 2°C (§5.2). |
| Rated charge | 15 A maximum. The fast-charge test uses 15 A to 4.20 V, followed by constant voltage to 100 mA at 25 ± 2°C (§§3.10, 6.1.3). |
| Charging time | ≤2 hours for standard charge (§3.7). The separate charger-design timer at 5 A is listed as 1.5 hours in English and 4 hours in Chinese (§10.1). Section 13 gives the Chinese text precedence. |
| Standard discharge | 1 A (0.2C) to 2.50 V at 25 ± 2°C (§5.3). |
| Max. continuous discharge current | 50 A without the 80°C cutoff, or 80 A with an 80°C cell-surface cutoff (§3.11). See the pack-design limits above. |
| Max. pulse discharge current | 200 A for 10 seconds at 25 ± 2°C (§3.9). |
| Charge cut-off voltage | 4.20 V, with 100 mA termination during the standard constant-voltage phase (§§3.4, 5.2). |
| Discharge cut-off voltage | 2.50 V standard discharge endpoint (§§3.5, 5.3). |
| Cycle life (high-rate, 30A) | ≥60% of initial capacity after 600 cycles with 8 A charging, or after 200 cycles with 15 A charging. Both tests discharge at 30 A to 2.50 V at 25 ± 2°C (§§6.1.8, 6.1.10). |
| Cycle life (high-rate, 40A) | ≥60% of initial capacity after 500 cycles with 8 A charging and 40 A discharge to 2.50 V at 25 ± 2°C (§6.1.9). |
| Retention characteristics | ≥90% capacity recovery after recharge following 30 days of fully charged storage at 60 ± 2°C (§6.1.12). |
| Initial impedance | Cell internal resistance ≤4.0 mΩ (§3.14). DC internal resistance ≤11 mΩ at 50% state of charge with a 5 A, 10-second discharge pulse (§6.1.2). |
| Operating cell surface temperature | Section 3.16 lists −10 to +60°C for charging and −40 to +80°C for discharge. It recommends resuming charge below 45°C after a thermal cutoff and requires discharge to resume below 60°C. Section 9.3 restricts charging to 0–60°C. The separate ambient ranges in §3.16 are −10 to +45°C for charge and −40 to +60°C for discharge. |
| Storage conditions | At 20–30% state of charge, −20 to +60°C for 1 month, −20 to +45°C for 3 months, or −20 to +25°C for 1 year (§3.15). For long-term storage, §8.2 recommends 0–20°C and relative humidity below 70%. |
| Shipment voltage | 3.580–3.600 V at factory shipment (§6.1.13). |
| Cell weight | 67.0 ± 1.5 g |
| Cell dimensions (with sleeve) | 21.35 ± 0.15 mm diameter × 70.7 ± 0.2 mm height, including the grey sleeve. |





Reviews
There are no reviews yet.